CYLINDER REPRODUCERS HAVE EITHER TWO MINUTE OR FOUR MINUTE STYLUS, OR
BOTH. IT IS BEST TO USE A SAPPHIRE STYLUS ON ALL 2 MINUTE CYLINDERS. USE DIAMOND TYPE
REPRODUCERS WITH 4 MINUTE CELLULOID CYLINDERS ONLY. WE OFFER MANY TYPES OF EDISON CYLINDER
AND DISC REPRODUCERS: BOTH NEW AND REBUILT ORIGINAL. ALL PARTS ARE TESTED AND GUARANTEED.
|
Postage, handling & insurance will be determined by the order
and ship-to location.
If remitting by mail, inquire to us for the amount to be added.
The p/h throughout the Catalog may not reflect the amount for your order.
Edison Cylinder Record Type complete rebuilding.
Service includes sapphire restored, diaphragm cleaned in ultra-sonic tank, (copper
only), adjustments and tested. |
Diamond Disc Reproducer Rebuild. With diaphragm restoration.
|
* Partial list of stock EDISON
Reproducers *
|
Inquire about other models.
* PARTIAL LIST OF STOCK EDISON REPRODUCER PARTS
*
* DIAPHRAGMS *
| $15.95 ea. |
MICA Comes with gaskets.
No eyelet. Specify with center hole or without. |
| $10.95 ea. |
| Mica was used prior to 1902 when recording technology was in its infancy.
Copper diaphragms were developed after the turn of the century as record companies
improved their product. Most collectors today prefer these later production
cylinder records and copper diaphragms. |
| Model H |
copper, complete |
$15.95 ea. |
| Model K |
copper, swivel center, complete |
$17.95 ea |
| Model L, N, R |
copper, complete |
$15.95ea. |
| Model Diamond C, A, and B |
laminated paper, cork, and woven link.Used on Amberola, Opera, and
other 4 minute phonographs. |
$38.95 ea. |
| Diamond Disc |
laminated paper, cork and woven link |
$38.95 ea. |
* GASKETS *
| Neoprene 'O' rings the same thickness and diameter as original. Give model designation
or diaphragm diameter. |
 |
| MODEL O,N,R,S,L,M, DIAMOND MODEL C,B,A. Used primarily with
Amberola and Opera model phonographs. Also used on many Triumphs, Standards, Homes,
Ideals, and Firesides. |
REPRODUCER RETAINER-RING REMOVAL TOOLS
* STYLUS *
| Mounted in new bar, (Except Model 0), easy to install. |
$85.00 ea. |
| Mounted in your bar. |
$70.00 ea. |
| Sapphire only. |
$58.00 ea. |
Send your reproducer to have sapphire mounted. We will clean,
inspect, and rebuild for approx. $68.00 (Model K: + $5; Model 0; + $10) Other
parts, if necessary, are extra.
SAPPHIRE 2 MINUTE. USED ON MODEL B AND AUTOMATIC. Also
Gem and Standard Speaker. Found on most Phonographs made prior to 1902.
| Mounted in new bar, easy to install. |
$85.00 ea. |
| Mounted in your bar. |
$70.00 ea. |
| Sapphire only. |
$58.00 ea. |
Send your reproducer to have sapphire mounted. We will clean, inspect, and
rebuild for approx. $68.00. Other parts, if needed, are extra.
SAPPHIRE 4 MINUTE. USED ON MODEL H,K,L,M,O,N,R and S. Specify
model.
| Mounted in new bar, easy to install. |
$85.00 ea. |
| Mounted in your bar. |
$70.00 ea. |
| Sapphire only. |
$58.00 ea. |
Send your reproducer to have sapphire mounted. We will clean,
inspect, and rebuild for approx. $68.00... Model K: + $5.00; Model 0: +
$10.) Other parts, if necessary, are extra.
DIAMOND IN BAR ...Specify 4 minute
(Diamond A, B, C)
or Diamond Disc. Comes in new bar, with new cross pin. |
$148.95 |
* MISCELLANEOUS *
| Usually the threaded end of the hinge block is broken off in the top of the
reproducer. Careful removal of this stud will allow the use of a block with the
same thread as original. Otherwise, redrill hole with 3/64" drill and order
oversize hinge block (0-80). |
| Includes new hinge block. We recommend a new replacement reproducer top when
there is extensive damage to hinge block area. Send the entire reproducer to APSCO.
with approx. $68.00 for complete rebuild when done with hinge block installation. |
  EDISON HINGE SPRINGS. For Diamond Disc and Diamond Cylinder
Reproducers. Send broken sample or tracing. |
* HORNS AND HORN SUPPORTS *
 |
$59.95 |
| HORN, same as offered above with unpainted body and
unpolished bell. |
| Not available at this time |
 |
$47.95 |
 |
Not available at this time |
See "Fireside and Gem Horn Crane" below.
See "Horn Decals" in 'CABINET CARE AND
REFINISHING.'
INQUIRE ABOUT AVAILABILITY AND DESCRIPTION OF ORIGINAL HORNS. |
| Necessary to join any cylinder phonograph reproducer to its horn when suspended
with a crane of any type . |
 |
* CRANES * |
| MORNING GLORY HORN CRANE |
$99.95 |
| For full-size horns. Approx. 30" - 33". Complete with rubber connector
and 4 tack bumpers. Use on Standard and Home. |
|
|
|
| Mounts directly in Fireside or Gem casting. When ordering for Gem,, specify
3/16" or 1/4" hole diameter. Use with Fireside and Gem Horn listed
above. |
 |
Use on Triumph, Home, Standard, Fireside,, and Ideal with Oak Music Master horn,
ten or eleven panel horn. Specify model and carriage-type so
that we can provide the proper crane for your particular set-up. The shape of the
crane varies for each combination and is important for proper fit. |
| New, nickel-plated. For proper positioning of horn on reproducer, dictated by
carriage type and horn set-up. |
AMBEROLA 30 GRILLES
Inquire about possible availability of other
grills. Provide model ID.
APSCO
7994 CR 10, PO Box 123
Davenport Center, N.Y. 13751
voice: 607-278-6218
fax: 607-278-6218
Email:
apsco@antiquephono.com
|
General
Information:
CompanyEmail
Copyright © 1997
CompanyLongName
email: apsco@antiquephono.com
Last modified:
October 19, 2016 |
|
